I started making cloth books the turn & topstitch way pictured above on the left. But I wanted FAT pages to highlight the colours of My Chewable Book of Wheels. And I liked the result so much that I no longer make skinny books. (The original skinny book tutorial is here.)
Fat Cloth Book Tutorial
You can click each photo for a closer look.
Get your fat quarter book panel from Spoonflower. Read all the steps below while you wait for your book panel (or panels?) to be delivered.
Cut your fabric along the solid grey lines into three strips as shown.
Carefully cut slits along the centre of the red spines between pages 1+10, 3+8, 7+4 as indicated below. This is the gap that you’ll be turning through. Make sure the slit doesn’t go past the white and into the colour.
Now fold the printed sides together, folding along the dashed grey line in the centre of each strip. Place a piece of polyester fleece padding under each folded strip. I recycle fleece baby blankets bought from a charity shop but you can also buy them from superstores or buy poly fleece from a fabric shop. And a ribbon if you want one on the spine. NOTE! Seal both ends of your ribbon. This will stop it from fraying; if your ribbon frays inside your book it might pull away from the book in the wash or in the hands of an enthusiastic toddler.
This photo is just to double check that you have the correct sides together. I pull the ribbon out through the slit so that the excess doesn’t get caught in the seam.
If you are using ribbon, make sure it lines up with the red spine printed on the fabric. I put a single twist in the ribbon so that later it will fit neatly on a wooden teething ring.
Now sew each page up. Sew along all four sides all the way around. (Technically you don’t have to sew the folded side but it won’t look the same as the other sides if you don’t.) You don’t need to leave any gaps because you can turn through the slits you cut in the spines earlier. I also add a clear cereal packet to the cover for a crinkly sound.
Trim the excess fabric and round the corners.
Very carefully, turn each page spread the right way around through the openings. Make the slits a little longer if you have to rather than stressing or ripping the fabric.
This is when I get the pins out and pin the fabric to help the slits stay closed.
Now for the tricky bit.
Change the thread to red.
Turn the cover page over and sew a single line along the centre of the ribbon to hold it in place. I do this with the cover only. Putting the book together at this stage and running that single line down through all three spreads never worked for me and my machine.
Once the ribbon is secured, position the other two page spreads underneath the cover, with the red spines lined up as precisely as possible. Hold it all together with your hands or pins or clips, and sew two red lines down both sides of the centre line, as close as possible to the edge of the ribbon.
Sewing a fat spine this way hides those slits from view and seals up your cloth book.
And there you have one FAT chubby cloth book for baby!
But if that looks like too much work for you, don’t fret…
You can buy a ready-made FAT cloth books here.